Atec Fluke-TN2100 - Manual

Technical Data
Te r m i n a t o r
T M
Far End Terminating Device
Team up Terminator with the 990 CopperPro – and see what
a difference Fluke Networks’ SuperVision makes.
The CopperPro TM family of loop testers
from Fluke Networks packs a full com-
plement of test and troubleshooting
capabilities into one rugged, integrated
tool for OSP technicians. Now we’ve
expanded its capabilities even further
with Terminator – an accessory module
to the 990DSL CopperPro TM that lets you
perform terminated transmission test-
ing quickly. Easily. Single-handedly.
Together, the CopperPro and
Terminator are a major advance in
qualifying and troubleshooting copper
access network circuits, including
HDSL2/4. Nothing else on the market
offers a more complete and effective
solution for reducing failure frequency,
repeats, and chronic problems with
special services circuits.
“Terminate” wasted time,
money and dispatches
Just attach the battery-powered
Terminator to the far end of a cable pair.
Together with a single 990 CopperPro,
Terminator provides VF and WB termina-
tions and tones for terminated transmis-
sion testing. It also supports the 990DSL’s
composite tone generation capability for
high-speed ADSL, special services, and
wideband longitudinal balance tests.
The bottom line? By reducing failure
frequency, repeats and chronic problems,
Terminator puts an end to unnecessary
dispatches and fines.
Save time and money. Gain
higher performance.
• Saves money and optimizes your workforce
with “one tech out” terminated testing of
out-of-service pairs
• High-speed acceptance/qualification tests,
including loop attenuation – a must for
HDSL2/4
• Robust error checking at start-up
eliminates time-consuming false starts
and assures reliable communication with
the CopperPro
• High-speed testing makes technicians
more efficient; the CopperPro’s unique
composite tone capability can sweep
thousands of frequencies in seconds
Terminator: one add-on
module; 13 testing advantages
1. Loop terminations and VF/WB single
tones for testing on either of two pairs
(Pair 1 and 2)
2. Bridging/splitting access between Pair 1
and Pair 3 (CO Pair)
3. Composite VF and WB tones for greatly
increased testing speed
4. DTMF signaling control on both Pair 1 and
Pair 2 (Pair 1 alone, if powered down)
5. Signaling and testing on the same pair
(either Pair 1 or 2)
6. Extremely low-power mode when
turned off
7. DTMF transceiver switchable via relay to
either Pair 1 (default) or Pair 2, or
removed from both for a preset time
interval whenever its input impedance
would affect the 990 CopperPro measure-
ment from the far end (i.e., shorts and
grounds, or opens)
8. Operable from a standard butt-set, when
line powering is present (i.e., idle
POTS line)
9. DTMF command protocol allows for
“Ack/Nack” closed-loop feedback
response to control commands,
increasing reliability
10. Tracing Tone mode (TR metallic 577 Hz
signal)
11. Powered by a standard, off-the-shelf
9 VDC alkaline non-rechargeable battery
12. Battery cover removable without using
a tool
13. Operates from an external 12-15 VDC
power source, such as the AC and DC
power cords provided with the
990 CopperPro, automatically discon-
necting the internal battery when
plugged in