Atec Megger-HT1000-2 - Manual

HT1000/2
Copper Wire Analyzer
HT1000/2
Copper Wire Analyzer
DESCRIPTION
The HT1000/2 is a high performance, full feature, hand held
instrument designed to provide copper wire provisioning and
maintenance technicians with the most critical tests at the
touch of a button. Durable and water resistant, the HT1000/2
is equipped with a highly effective 1/4 VGA LCD screen
and a powerful backlight designed to make testing and
troubleshooting easier in all work environments.
The on-screen menu launches most tests with a single
keystroke.
Super Stress ™ reaches beyond standard longitudinal balance
testing, identifying even hard to find short loop unbalances.
Dual trace TDR is standard, with 12 trace storage and
intermittent fault location.
The HT1000/2 has user selectable auto tests with an
incremental pair testing process.
Test for DC and AC volts at the same time, no need to switch
between separate screens.
Download updates and upload test results quickly and easily
via the integrated USB port.
FEATURES
Easy to navigate and launch testing; many of the standard 26
tests begin with the push of a single button: either from the
numeric keypad, or the soft key navigation pad.
n Direct access to tests: no cumbersome menus. Adds to ease
of training new technicians.
n Voltage, resistance and all standard telecom testing is
accessed through the same simple menu layout.
n Super Stress - this test is ten times more sensitive than
other technologies available today. What that means is
imbalances in twisted pairs can be seen below the 0dB
threshold, zeroing in on those imbalances hiding in short-
wire loops.
n Automatic Super Stress mode - aids technicians in finding
invisible faults on short wire loops.
n All transmission and noise tests for voiceband are included
along with an open meter which is pinpoint accurate, even
in the presence of shunt resistance (dirty open).
n TDR - the built-in TDR locates shorts, crosses and opens
at distances ranging from the end of the test leads to
14.7 km (45,000 ft). It can trace two pairs simultaneously
with pair comparison mode to identify potential cable
trouble spots.
n Dual trace TDR allows technician to compare good pair to
questionable pair - reads accurately to open or shorted pair.
TDR traces can be saved and uploaded to PC for review.
n Auto test / incremental pair test - user can configure up to 8
series of tests to run automatically.
Used in conjunction with the incremental pair test and bulk
pair recovery.
n Built in pair recovery program allows technician to gather
data on defective pairs and troubleshoot faults.
Store test results - The HT1000/2 stores test results data in
a comma delimited format which can be uploaded via the
integrated USB port to a customer-driven database.
n Download firmware updates - via the integrated USB port.
n Spectrum analyzer - loss readings up through the VDSL
range test protocols.
n
Noise finder via a 30 MHz spectrum analyzer
n
7 user selectable auto tests
n
Incremental pair test program
n
200 pair pre-post test storage
n
AC or DC power
n
USB port downloads updates and uploads
test results