Atec Anritsu-MS2711 - Manual (Page 2)

SPECTRUM ANALYZERS
124 www.anritsu.com For product ordering information, see pages 4-7.
Specifications
Frequency range 100 kHz to 3.0 GHz
Frequency reference
Aging: ±1 ppm/yr
Accuracy: ±2 ppm
Frequency span 100 kHz to 3 GHz plus zero span
Sweep time 0.5 sec.
Resolution bandwidth
10 kHz, 30 kHz, 100 kHz, 1 MHz, ±20%
(–3dB width)
Video bandwidth
3 kHz, 10 kHz, 30 kHz and 300 kHz
(Range –3dB)
SSB Phase Noise
@30 kHz Offset
≤–74 dBc/Hz
Spurious responses Input related: ≤–45 dBc
Residual responses ≤–80 dBm
Measurement range –90 dBm to +20 dBm
Dynamic range ≥60 dB
+20 dBm max. measurable safe input
Maximum safe input level
+50 Vdc
Displayed average
noise level
≤–90 dBm
Display range
2 to 15 dB/div. In 1 dB steps
Ten divisions displayed
RF input VSWR 2.0:1
Amplitude accuracy ±1.5 dB
Total level accuracy ±2 dB
Internal trace memory 200 maximum
Instrument configuration 10 setup locations
RS-232 9 pin D-sub, three wire serial
Electromagnetic compatibility Meets European community requirements for CE marking
Temperature
Operating: 0°C to 50°C, humidity 85% or less
Non-operating: –20°C to +75°C
Power supply External DC Input: +12.5 to +15 volts dc, 1100 mA max
Size
25.4 cm (W) 17.8 cm (H) x 6.10 cm (D)
10.0 in (W) x 7.0 in (H) x 2.4 in (D)
Weight 1.82 kg (4 lbs.) includes battery
Frequency
Amplitude
General
Except where noted otherwise, specified values are obtained after warming up the Anritsu MS2711 Handheld Spectrum Analyzer for 5 minutes at a constant
ambient temperature. The typical values are given for reference and are not guaranteed.