Atec Agilent-8568b-8566b - Manual (Page 5)

5
CISPR EMI Amplitude
Parameter Specification
Measurement range +137 dBµV to noise floor (refer to amplitude sensitivity table)
Amplitude accuracy8
(+10° to +30°C, 0 – 20 dB RFP atten.) ±2.0 dB for 10 dB SA atten.
± 2.5 dB for 0 dB SA atten.
Calibration10 Automatic calibration for absolute amplitude with comb
generator (RFP)
Linearity check 3 dB input attenuator test for system overload and distortion
(RFP)
Impulsive signal tolerance Input #1 withstands LISN transients (RFP)
Input #2 withstands CISPR calib. pulses (RFP)
Detection9 Peak and average (SA), quasi-peak (QPA)
Audio output Speaker with volume control (QPA)
CISPR EMI Amplitude sensitivity
EMI receiver Specification
Frequency band Resolution bandwidth (6 dB) Average noise6
(RFP/SA atten. = 0 dB) Quasi-peak noise
(RFP/SA atten. = 0 dB)
10 – 150 kHz (band A) 200 Hz -12 dBµV4
-17 dBµV typical -15 dBµV (nominal)
150 kHz – 1 MHz (band B) 9 kHz +4 dBµV
-1 dBµV typical 0 dBµV (nominal)
1 – 30 MHz (band B) 9 kHz -13 dBµV
-16 dBµV typical -11 dBµV (nominal)
30 – 1000 MHz (band C, D) 120 kHz -1 dBµV
-6 dBµV typical 0 dBµV (nominal)