Atec Amplifier-Research-500T1G2 - Manual (Page 2)

Page 2 of 3
SPECIFICATIONS, MODEL 500T1G2
POWER (fundamental), CW, @ OUTPUT CONNECTOR
Nominal ................................................................537
watts
Minimum ...............................................................500 watts
Linear @ 1 dB Compression ...................................125 watts minimum
FLATNESS.....................................................................±8 dB maximum, equalized for
±5 dB maximum at rated power
FREQUENCY RESPONSE ...............................................1–2.5 GHz instantaneously
INPUT FOR RATED OUTPUT..........................................1.0 milliwatt maximum
GAIN (at maximum setting) ...........................................57 dB minimum
GAIN ADJUSTMENT (continuous range).........................35 dB minimum
INPUT IMPEDANCE.......................................................50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE ...................................................50 ohms, VSWR 2.5:1 typical
MISMATCH TOLERANCE...............................................Output power foldback protection at reflected power exceeding 100 watts. Will
operate without damage or oscillation with any magnitude and phase of source
and load impedance. May oscillate with unshielded open due to coupling to
input. Should not be tested with connector off.
MODULATION CAPABILITY...........................................Will faithfully reproduce AM, FM, or pulse modulation appearing on the input
signal. AM peak envelope power limited to specified power.
NOISE POWER DENSITY ...............................................Minus 80 dBm/Hz (maximum)
Minus 87 dBm/Hz (typical)
HARMONIC DISTORTION.............................................Minus 3 dBc maximum
Minus 4 dBc typical
PRIMARY POWER .......................................................... See Model Configurations
CONNECTORS
RF input .................................................................Type N female on rear panel
RF output ...............................................................7–16 DIN female on rear panel
RF output sample port ............................................Type N female on rear panel (Forward Power)
GPIB......................................................................IEEE-488 (f)
Interlock ................................................................DB15 on rear panel
COOLING....................................................................Forced air (self-contained fans), air entry and exit in rear.