Atec ENI-EI-1040L - Manual

1387 Brighton Henrietta Townline Rd
Rochester, NY 14623
Tel: (585) 214 0598
Fax: (585) 214 0580
www.eandiltd.com
400 Watts of RF Power
For Industrial, Lab
& Medical Use,
Featuring;
- 10 KHz
– 5 MHz
- Power Measurement
o Forward & Reflected
- Solid State Reliability
- Forced Air Cooling
The 1040L Amplifier is a rugged source of RF
power for ultrasonics, induction heating and
laser modulation as well as plasma applications.
It is a totally solid state solution employing RF
DMoS FETs in the power amplification stages,
offering simultaneous forward and reverse
power readouts, and RS232 port for data
collection
. The 1040L reflects E&I’s commitment
to reliable and robust RF power.
Flexible Operation:
The 1040L produces 400 Watts of quasi linear
class AB power over a frequency range of 10
KHz to 5 MHz, with a nominal power gain of 55
dB (+/-1dB). Operation over the entire frequency
range is possible without the need for any
switching.
The front panel display provides simultaneous
measurements of forward and reflected power
as well as the unit’s status. The RS232
connector at the rear of the unit can also be
used to capture this data and reset the unit
should a fault occur.
The E&I 1040L
is a 19” rack mount unit 3U high.
It employs an integral power supply capable of
operation at 115 or 220 VAC, 50
– 60 Hz. The
unit weighs approximately 45 lbs or 16 Kg.
1040L
POWER AMPLIFIER