Atec Chroma-63600 Series - Manual (Page 8)

1. LCD Display: Used for setting and measurements
2. MODE key: Used to select the operating mode : CC, CR, CV, CP or CZ
3. DYNA key: To select dynamic test mode
4. EDIT key: Used for setting and editing
5. SHORT key: Used to apply a short circuit across the input
6. ADVA key: Used to select the other testing functions
7. Enter key: Used for confirming data entry
8. Voltage sense terminal
9. A/B key:
Used to select static A or B load (63630, 63640)
L/R key: Used to select left or right channel of input load (63610)
10. DATA key: Used to select the other parameters
11. RANGE key: Used to select HIGH, MIDDLE or LOW loading range
12. Rotary knob: Used to adjust loading and parameter setting
13. Cursor key: Used for setting and editing
14. LOAD key: Used to enable or disable the load input
15. Module lock: Used to remove the module
16. Load terminal
17. Power switch
18. LED display: Used to display the memory address
19. Up / Down key: Used to select the next or previous memory address
20. SPEC key: Used to setup High/Low limits for GO/NG test
21. LOCK key: Used to lock the setting data
22. SAVE key: Used to save the front panel input status into memory
23. RECALL key: Used to recall the front panel input status from memory
24. LOCAL key: Used to recover local control
25. Shortcut key: Used to save loading profile for all channels
26. Voltage & Current monitor output: Analog output to proportional to
the voltage and current waveform
27. V EXT: Input for external wave in control
28. System I/O: Used for system input/output control signals
29. Ethernet connector
30. System Bus:
Used for master/slave control system data communication
31. USB connector
32. GPIB connector
33. AC input fuse
34. AC Input connector
OrdErINg INFOrmATION
63600-1 : 63600 Mainframe for Single Modules
63600-2 : 63600 Mainframe for 2 Modules
63600-5 : 63600 Mainframe for 5 Modules
63610-80-20 : DC Load Module, 80V/20A/100Wx2
63630-80-60 : DC Load Module, 80V/60A/300W
63630-600-15 : DC Load Module, 600V/15A/300W
63640-80-80 : DC Load Module, 80V/80A/400W A636000 : GPIB Interface for 63600-2/63600-5 Mainframe
A636001 : Ethernet Interface for 63600-2/63600-5 Mainframe
A636003 : External Signal Board (Test Pin) for 63600-2/63600-5 Mainframe
A636005 : External Signal Board (BNC) for 63600-2/63600-5 Mainframe
A636007 : Rack Mounting Kit for 63600-2 mainframe
A636008 : Rack Mounting Kit for 63600-5 mainframe (for Europe only)
A632006 : NI USB-6211 Bus-Powered Multifunction DAQ
PANEl dESCrIPTION
1
2
9
10
3
4
5
6
7
11
12
13
14
8
16
15
17 18 19 20 21 22 23 24 25
26 27 28 29 30 31 32 33 34