Atec AEMC-PEL103 - Manual

Models PEL 102 & PEL 103
POWER & ENERGY LOGGER
PEL 100 Series
Technical Assistance (800) 343-1391 www.aemc.com
 FEATURES
• Simple to use, single-, dual- (split-phase)
and three-phase (Y, ∆) power & energy loggers
• Provides all the necessary functions for
Power and Energy data logging for 50Hz, 60Hz,
400Hz and DC distribution systems
• Current measurements from 200mA up to
10,000A using flexible current sensors
• Automatic recognition of the connected current
sensors/probes
• Power measurements: VA, W and var
• Energy measurements VAh, Wh (source/load
indication) and varh (including quadrant indication)
• Record cost of energy usage
• Power Factor (PF), Cos (ϕ), Tan (Φ) and DPF
• Total Harmonic Distortion (THD) for voltages
and currents
• Harmonics up to the 50 th order for 50/60Hz
voltages and currents and 7th order for 400Hz
• Simultaneous RMS measurements of each phase
@ 128 samples/cycle and DC
• Bright blue, four line LCD on Model PEL 103
(3 phases shown simultaneously)
• Storage of measured and calculated values
on a SD-Card or SDHC-Card
• Configuration of current and voltage ratios
to external PT and CT ratios
• USB, LAN, and Bluetooth communication
• Includes DataView ® software for data
storage, real-time display, analysis and report
generation with supplied pre-defined or custom
templates
NEW!
R ATIN G
SAFETY
Economical, compact and
simple to use!
TM
ETHERNET
 pRodUcT inclUdES
Models PEL 102 & PEL 103
Models PEL 102 and PEL 103 include:
Small Classic Tool Bag, Three MiniFlex ®
MA193-10-BK Sensors (included with select
models), 5 ft USB Cable, Four Black Test Leads
and Alligator Clips, Power Cord, 12 Color-coded
ID Markers, Multifix Mounting System, Safety
Card for the PEL, Sensor Compliance Sheet, 2
GB SD-Card with USB-SD-Card Reader,
Quick Start User Guide and USB Stick
with DataView ® and User Manual.
Measured Phase
Indicator
Measurements
or Page Title
Information
Display
Bar
Mode Selection
Display Bar
Bargraph
(Load factor -
Min - Max). The
bargraph indicates
the percentage
(0% to 100%) of full
range or full load
as programmed
into the PEL by the
user through the
DataView ® software.
Measurement Values
Measurement
Units
 KEy FEATURES oF ThE pEl 103 diSplAy
 Top And BoTTom diSplAy BARS indicATE ThE Following
TOP DISPLAY BAR
ICON DESCRIPTION
Phase Sequence reversal indicator or missing
phase (displayed in 3-Phase distribution systems)
Data available for recording (non-display indicates
possible internal problem)
Power Quadrant Indication
BOTTOM DISPLAY BAR
Measurement Mode (Real-time values)
Power and Energy Mode
Harmonics Mode
Min/Max Mode
Information Mode
Not used