Atec AR-CI00250A - Manual

Approved for public release by AR RF/Microwave Instrumentation 111412
160 School House Road Souderton, PA 18964-9990 • 215-723-8181 • www.arworld.us Page 1 of 2
Model CI00250A,
M1 through M12
RF Conducted Immunity System
75 Watts
10 kHz–250 MHz
Complete Testing Solutions to the following standards:
• EN/IEC 61000-4-6
• IEC 60601-1-2
• EN 50130-4
• EN 61000-6-1/2
• EN 55024
• CISPR 14-2
The Model CI00250A is a fully self-contained state of the art system
designed to test RF Conducted Immunity. The CI00250A contains all the
instruments needed to perform conducted immunity testing to the IEC
61000-4-6 specification. The system contains a signal generator, 3 channel power meter, 75W minimum AR amplifier
10kHz to 250MHz, and emcw
ar e® control software. Everything is contained in a single housing, which eliminates setup
issues. This system will have the versatility needed for every test laboratory and equipment manufacturer. The RF amplifier
and the signal generator can be used independently of the system. If special needs arise or standards were to change a
larger amplifier can be connected to the system. The use of spectrum analyzers and monitoring equipment may also be
controlled by the software.
The export classification for this equipment is EAR99. These commodities, technology or software are controlled for export
in accordance with the U.S. Export Administration Regulations. Diversion contrary to U.S. law is prohibited.
Internal Test Specifications*
IEC/EN 60601-1-2
IEC/EN 50130-4
IEC/EN 61326
IEC/EN 61000-6-1
IEC/EN 61000-6-2
CISPR 24/EN 55024 IEC 61000-4-6 procedure and
levels
*Specifications can be met using AR-specified external
accessories (injection probes, monitor probes, cal fixtures,
CDN’s, attenuators, etc.) Contact AR for further information.
Signal Generator Specifications
SG1200 SG6000 (optional)
Frequency range
resolution
9 kHz to 1.2 GHz
1Hz
100kHz to 6 GHz
0.01 Hz
Power range
resolution
-140 to +13 dBm
0.1dB
-110 to +7 dBm
0.02 dB
Modulation AM, FSK. FM, Phase,
External Pulse AM, FM, Phase,
Internal/External
Pulse
Power Meter Specifications
Channels 3
Power heads 1
Type diode
Frequency 10kHz to 8GHz
Range -60 to +20 dBm
RF Amplifier Specifications
Frequency range 10 kHz to 250 MHz
Power rating 75Watts Minimum
1dB compression 50 Watts Minimum
Harmonic Distortion -20dBc at 50 Watts
Mismatch tolerance 100% of rated power without
fold back. Will operate without
damage or oscillation with any
magnitude of source and load
impedance.
Gain 49dB minimum