Atec Agilent-U9391C-F-G - Manual (Page 4)

4
DC power supply
compatibility
Specifi cations U9391C/F U9391G
Voltage +15V +/- 10% Vdc +15V +/- 10% Vdc
Current 300 mA (nominal) 850 mA (nominal)
1. Current drawn will change when drive
voltage changes.
The U9391C/F/G can be powered by any DC power supply that is capable of
supplying at least 300 mA (nominal) at 15 ± 10% Vdc
1 (via the banana plug
cables provided).
Recommended DC power supply for U9391C/F: E3620A
Recommended DC power supply for U9391G: E3615A
Compatible DC power supply: All E36XXA series power
supply (except E3612A
and E3614A)
U9391C/F/G Drive Power Supply Specification
Alternative configuration
with squaring unit
If a signal generator is not available, the 10 MHz reference output on the back
panel of the PNA-X can be used as a signal source. However, the U9391-60009
sine to square wave converter is needed as the comb generator will not function
at its optimum level for output frequencies above 26.5 GHz, with a sine wave
input of less than 100 MHz. Therefore, U9391-60009 is included as a standard
accessory for U9391F and U9391G.
DUT Measurement
Phase Ref
Calibration
Phase Ref
IN IN OUT OUT
RCVR B IN
11636B
Power
Divider
10 MHz
Sine to
Square
Wave
Converter
PNA-X Back Panel
PNA-X Front Panel