Atec Agilent-E6601A - Manual (Page 5)

5
Internal OCXO Timebase
Output level range Typically 0 to +10 dBm
Aging rate < ±0.1 ppm/year
Temperature stability (referenced to +25 °C)
–10 to +70 °C
< ±0.05 ppm
Accuracy
After 30-minute warm-up
±[time since last calibration x
aging rate + temperature stability
+ accuracy of calibration]
Initial adjustment ±0.05 ppm
Locking range Typically ±0.2 ppm
Output frequency 10 MHz + locking range
Output impedance Typically 50 ohms
Synchronization Inputs/Outputs
External reference input
Locking range Typically ±0.2 ppm
Input frequency 1, 2, 5, or 10 MHz ± locking range
Input level range Typically 0 to +10 dBm
Input impedance Typically 50 ohms
Baseband triggers
Rear-panel input and/or output connections for format-dependent
synchronization with external equipment.
Bi-directional
DB9 connector
5 TTL triggers
Input
BNC connector
1 TTL trigger input
Output
BNC connector
1 TTL trigger output
General Specifi cations
Operating temperature range +10 to +55 °C
Storage temperature range –20 to +65 °C
Dimensions H x W x D 8.75 x 16.75 x 21 inches
222 x 426 x 533 mm
Weight 51 pounds
23.1 kg
AC power input 100 to 240 VAC,
50 to 60 Hz
AC power consumption Typically 260 W maximum
Calibration interval 2 years
Self alignment conditions
User alerted that automatic
self re-alignment is required
and can choose to align
then or to ignore until later > ±10 °C from last self align-
ment, or > 24 hours since last
RF generator self alignment or
> 30 days since last instrument
self alignment
Self alignment times
RF
generator Typically < 1 minute
Instrument and RF generator Typically < 5 minutes
EMC
Meets standards as listed
IEC 61326:2002 /
EN 61326:1997 + A1:1998 +
A2:2000 + A3:2003
Canada ICES-001:2004
Australia and New Zealand AS/NZS CISPR11:2002
Safety
Meets standards as listed
IEC 61010-1:2001 /
EN 61010-1:2001
Canada CSA C22.2 No. 61010-1:2004
USA UL 61010-1:2004
Radiated source leakage
Within cellular frequency
bands, at zero span with
10 Hz resolution bandwidth
and one inch (2.54 cm) from
instrument front panel and
from front half of all sides of
instrument surfaces Typically < 1 µV rms
Remote programming
GPIB
IEEE standard 488.2
LAN 1 RJ45 rear-panel connector
USB-B 1 rear-panel connector
External device connections
USB-A
2 front-panel USB 1.1
4 rear-panel USB 2.0