American Expedition Vehicles JK DualSport RS Suspension 3.5/4.5 - Manual (Page 8)

6
2. Disconnect the drive shaft at the Axle end. Make sure to mark both sides of the connection so you
can properly align it when you reconnect it (Fig. 12). Tie loose end of the drive shaft up so it will not
hang down. Failure to follow this step may result in damage to your drive shaft.
Figure 12
3. Remove the two bolts holding the automatic transmission skid plate onto the frame (Fig. 13). Located
in the Con Box you will find two large diameter washers. Place these between the skid plate and frame
then reinstall and torque bolts to 45 ft/lbs (Fig. 13).
INSERT SPACER
INSERT SPACER
Figure 13
4. Loosen but DO NOT remove all 8 control arm bolts.
5. Loosen but DO NOT remove the frame-side track bar bolt. Remove and save the axle-side track bar
bolt and flag nut (Fig. 14).
Figure 14