American Expedition Vehicles JK DualSport RS Suspension 3.5/4.5 - Manual (Page 6)

4
12. Install new Bump Stop Spacers on axle as shown (Fig. 7) using the supplied hardware. DO NOT reverse
the orientation from what is shown (screws should be inboard.)
Figure 7
13. Install new shocks at upper mount. NOTE: If installing Remote Reservoir Shocks, refer to figure 8 for
proper orientation to prevent damage to reservoir hose. It is critical that the hose for the remote reser-
voir shocks do not come into contact with any other parts. Remember that the shock will move as the
axle travels through its range of motion, so you must be very diligent in the routing of this hose.
REAR REAR
Figure 8
14. Raise axle slowly and guide springs into position.
Install AEV swaybar end links and tighten.* Re-install lower shock nut and bolt and tighten* (refer to
Fig. 4-B.) Install brake line drop brackets as shown (Fig. 9) and tighten.*
Figure 9
*Refer to Appendix for proper torque specs