American Expedition Vehicles JK Rear Bumper/Tire Carrier - Manual (Page 7)

5
B. INSTALL THE SADDLE BLOCK
1. Install the plastic Saddle Block using the
3/8”x1” bolts with 3/8” washers under the
head of each bolt. Install the bolt into the
countersink on the Saddle block. Use the 3/8”
Flange nuts on the inside surface of the AEV
Tire Carrier Bracket.
2. Adjust the Saddle Block to its MIDDLE adjust-
ment.
3. Using hand tools only torque the bolts down to
20 ft/lbs (27.1 N-m) max.
4. 2010+ MODELS ONLY: The exhauster on
2010s is wider than earlier models and must
have the top left corner trimmed in order to fit
the AEV Bracket.