American Expedition Vehicles JK Rear Bumper/Tire Carrier - Manual (Page 18)

16
5. The bumper should match the fender flares and have even gaps around the Corner Tubes, adjust as
necessary.
6. The Tire Carrier should swing with mild resistance, if there is too much the lower O-Ring can be
removed or a thin washer can be placed between the Retention Disc and the Tire Carrier Spindle if
necessary.
N. FINISHING DETAILS
1. Install the Plastic Tube end in the horizontal tube of the Tire Carrier.
2. Install the Plastic Plugs in the tailgate where the stock rubber bumpers were removed.
3. Shovel Install – Most shovels will need to have the handle cut down slightly in order to fit properly.
The most important thing is to have the blade of the shovel fit tightly against the tire in order to
provide enough resistance to hold the shovel in place. Its best to leave enough of the handle in place
that it sits on the outside of the tubing where the tire carrier and spindle are welded together, but not
hit the corner of the vehicle when fully opened.