American Expedition Vehicles JK Rear Bumper/Tire Carrier - Manual (Page 19)

17
O. INSTALLING ACCESSORIES
1. AEV CHMSL — The AEV CHMSL can be added if using any AEV wheel. NOTE, the AEV CHMSL will
not work with all aftermarket wheels, please check with the wheel manufacturer before purchasing.
When installing the AEV CHMSL, reuse the factory CHMSL wiring. CONNECT THE BLACK WIRE TO
THE WHITE WIRE AND WHITE WIRE TO THE BLACK WIRE.
2. PUMP KIT — Please see instructions in the Pump Kit box.
3. RECOVERY RACK — Please see instructions in the Recovery Rack box.
4. REAR BACK UP LAMP — When installing the IPF Backup Lamp 8161, install per IPF Instructions, use
the L1 (white/gray) circuit located in C5 (Brown), Cavity 15 underneath the TIPM for the rear backup
lamp feed. Use the provided zip ties on Tire Carrier.
5. ANTENNA — CB or shortwave antennas can be mounted to the Tire Carrier and routed to the front of
the vehicle on the right side of the vehicle. Some setups may require an additional ground strap for
optimal performance. Use the provided zip ties on Tire Carrier.
comments or questions?
American Expedition Vehicles
www.aev-conversions.com
email: [email protected]
ph: 248.926.0256
Be sure to visit our forum at: http://forum.aev-conversions.com