American Expedition Vehicles JK Rear Bumper/Tire Carrier - Manual (Page 4)

2
i. vehicle preparation
a. removal of the factory rear bumper
1. Remove the four bolts that attach each of the “L” brackets to the frame and bumper. SAVE the “L”
brackets and bolts for later use. MARK the “L” brackets Left and Right.
2. Remove the two bolts that attach each “S” bracket from the bumper and rear cross member. You can
discard the factory rear bumper, “S” brackets, and bolts if installing the AEV JK Rear Bumper. If you
are installing the AEV Tire Carrier only you’ll need to save this hardware.
“L” Bracket “S” Bracket