Alpha Technologies Serial System Controller - Manual (Page 23)

2. Installation
23 018-332-C0-002 Rev. B
© 2001 TM
Figure 2-1; Location of Communications Module in XM2 Power Supply
Note: If the XM2 system already has a Serial System Controller (SSC)
module installed, proceed to section 2.3, “Smart Display Setup
Menu.”
Note: During this procedure, backup capability may be temporarily lost.
Module Conversion Procedure:
1. Disconnect any status monitoring cables/harnesses connected
to the front panel of the existing module. (Module shown for
illustrative purposes only.)
2. Verify that the battery breakers are OFF.
3. Disconnect the battery cable connections.
4. Unscrew the captive mounting/grounding screws located on the
lower front panel (and top right, if applicable) of the Inverter
Module (IM).
2.1 Module Conversion
1
2
3
4
®
TM