Alpha Technologies CE3G User Manual

Page 17

Text mode
Original mode

745-738-C0-001 Rev. A

Install the LP1 and LP2 Module (part of the
wire harness) onto the respective cylinders
using the following instructions:

1. Remove the dust cap by sliding it from

the dial, and clean the cavity under dust
cap

2. Slide module into slot on dial from edge

of dial. Do not attempt to install module
vertically.

3. Apply thumb pressure in area provided

and push module toward center of
dial until it snaps in place. Repeat
procedure for second tank. Connect
other end of wire harness to J1 of Fuel
Relay PCB.

To remove the module, apply slight upward
pressure on the wire side of the module,
apply thumb pressure and slide module to
the outer edge of the dial.

1.2 Installation, continued

1.2.5 Sensor Module Installation

Fig. 1-15, Dust Cap Removal

Fig. 1-16, Sensor Module Installation

Fig. 1-17, Completed Sensor Installation

NOTE

Debris in the cavity prevents the module from properly
seating and accurately sensing the fuel level.