Alpha Technologies CE3G - Manual (Page 12)

12 745-738-C0-001 Rev. A
1.2 Installation
1.2.1 Installing Alarm Housing
1. Disconnect and remove Ignition Battery.
2. Install the Fuel Quantity Alarm Relay PCB and mounting bracket by removing
fastener backing and pressing module into place on a clean surface on the the
side of the ECM housing.
Remove backing
Fig. 1-1, Alarm Housing Fastener Strips
Attach to side of ECM housing
Connect P1 here
Fig. 1-2, Alarm Housing Placement
Fig. 1-3, Cable Routing
3. Connect P1 of wire harness (Alpha P/N 875-419-20-XXX) to J1 of the Fuel
Quantity Alarm Relay PCB as shown below
4. Route cable along front of battery tray and secure with cable tie.