Alpha Technologies CE3G - Manual (Page 16)

16 745-738-C0-001 Rev. A
1.2 Installation, continued
1.2.4 Cable connection and Routing, continued
5. Tighten strain relief for sensor module cables.
Pivot LFPS
assembly
Tighten fi tting
7. Use AMP contact insertion tool (P/N 91002-1) to reattach LFPS connector.
Tighten the sealing nut on the watertight fi tting at this time.
6. Route the LFPS wires through the bulkhead fi tting and nut. Pivot LFPS assembly
to original position and retighten (fi nger tight plus ¼-turn) the fl are fi tting.
Fig. 1-13, Reposition LFPS
Tighten strain relief
Fig. 1-12, Wiring Inside Gas Box
LFPS Wires
Fig. 1-14, Wire Arrangement, Generator Cabinet Side
Tighten nut
LFPS Connector
NOTE
Before returning the system to service, all gas fi ttings must be leak tested and leak tight.