Alpha Technologies FlexNet PMR, GMR Series - Manual (Page 46)

46
031-239-C0-003 Rev C
4.0 Equipping the System, continued
4.8 Optional Fan Kit Installation, continued
To install the fan kit:
Remove the enclosure lid.
Holding the fan unit, with side fl anges toward the rear of the enclosure, slide the fl anges
into the slot under the rear lip of the enclosure. See Fig. 4-21.
After the rear of the unit is fi rmly placed, loosen the wing nuts on the slide rails.
Extend the rails until they are fi rmly seated against the front of the enclosure. Tighten the
wing nuts.
Plug the power cord into the outlet located on the left side of the enclosure.
Replace the lid of the enclosure.
1.
2.
3.
4.
5.
6.
Fig. 4-21, Placing Fan Unit
Fig. 4-22, Extending Side Rails
Fig. 4-23, Completed Fan Install