ABUS FU8230 Secvest Wireless Indoor Sounder - Manual (Page 12)

12
Attaching the rear housing wall
1. Using the base plate as a drilling template, mark the drill
holes on the wall. Drill the holes and insert wall plugs if
necessary.
2. Feed the connection cable of the PSU into the device and
screw the rear housing side onto the wall (optional).
3. Supply the internal siren with power (either 4.5 V or 12 V,
or both - the polarity of the terminal block is printed on the
PCB).
Assigning the Secvest to the wireless internal siren
1. Set the “LEARN” jumper. LED1 starts to flash. Learning
mode is now active.
2. In the installer menu of the wireless alarm centre, select
the “Other Devices
 Info Module/Int Siren  Teach
Device” menu point.
3. Press “Send” on the wireless alarm centre.
The centre sends the learn signal to the internal siren.
After successful learning of the wireless alarm centre:
• The internal siren emits a double tone.
• LED1 goes out.
4. Remove the “LEARN” jumper. The ID of the alarm centre
is saved in the internal siren. The internal siren emits a
double tone.
5
6
2
1
4
3