AAEON EMB-BT1 - Manual (Page 25)

2-17 Chapter 2: Motherboard information
5. Serial ATA 6.0Gb/s connector (7-pin SATA6G_1, SATA6G_2)
ThIS connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
IMPORTANT:
• You must install Windows
® XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section 3.3.7 IDE Configuration for details.
EMB-BT1 SATA 6.0Gb/s connectors
SATA6G_2 SATA6G_1
GND
RSATA_RXP2
RSATA_RXN2
GND
RSATA_TXN2
RSATA_TXP2
GND
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
6. SATA power connector (4-pin SATA_PWR1)
This connector is for the SATA power cable. The power cable plug is
designed to fit this connector in only one orientation. Find the proper
orientation and push down firmly until the connector completely fit.
EMB-BT1 SATA POWER Connector
+12V
GND
GND
+5V
SATA_PWR1