AAEON IMBA-H61A - Manual (Page 39)

Chapter 3: BIOS setup 3-9
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor
system. When read/write of your hard disk errors occur, this feature allows the
hard disk to report warning messages during the POST. Configuration options:
[Enabled] [Disabled]
Hot Plug [Disabled]
This item only appears when you set the SATA Mode Selection item to [AHCI]
and allows you to enable or disable the hot-plug support for each SATA port.
Configuration options: [Enabled] [Disabled]
3.4.5 System Agent Configuration
Memory Remap Feature [Enabled]
Enables or disables the memory remap feature. Configuration options: [Enabled]
[Disabled]
Graphics Configuration
Primary Display [Auto]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [Auto] [iGPU] [PCIE] [PCI]
iGPU Memory [Auto]
Allows you to select the system memory size allocated to DVMT 5.0 used by iGPU.
Configuration options: [Auto] [32M] [64M] [96M] [128M] ~ [448M] [480M] [512M]
[1024M]
Render Standby [Enabled]
Allows you to enable Intel Graphics Render Standby support to reduce the power
consumption for iGPU while the system is idle. Configuration options: [Disabled]
[Enabled]
iGPU Multi-Monitor [Disabled]
Allows you to enable or disable iGPU Multi-Monitor support for add-on graphics
devices. The iGPU shared memory size will be fixed at 64MB. Configuration options:
[Disabled] [Enabled]