Cla-Val 736-01 - Manual

Solenoid Control Valve
Din drilling available on all sizes
Material Specification
Body: 316L Stainless Steel
Liner: Natural Rubber, 65 durometer (standard)
Viton, EPDM, Nitrile, Silicone (available)
Liner Retainer: 316 Stainless Steel
Solenoid Pilot
Body: Brass *
Wetted Parts: Brass/Stainless Steel * , Buna-N ®
Accessories
Shut-off Isolation Valve: Brass *
Speed Controls: Brass *
Check Controls: Brass *
“Y” Strainer: Bronze *
Control Piping: Copper *
Control Fittings: Brass *
* 316 stainless steel available
736-01
Purchase Specification
The three-way solenoid pilot alternately applies pressure to or
exhausts pressure from the loading chamber of the main valve which
in turn causes the main valve to open or close.
The control valve shall be constructed of two parts: a stainless steel
body, and an elastomeric liner or control element. Minimum rangeability
shall be 500:1 based on capacity at flowing pressure conditions. C
f
shall be greater than or equal to 0.9. Valve and control system shall
be similar in all respects to Cla-Val Model 736-01 as manufactured
by Cla-Val, Newport Beach, California.
Performance Specification
Capacity: See Technical Data Sheet
Cf Factor: 0.9
Cavitation: See Technical Data Sheet
Rangeability: 500:1
Bearing Friction: No friction from slip-type
bearings
Design Specification
Sizes: 2, 3, and 6 inch wafer style
6, 8, 10, and 12 inch flanged
End Detail Wafer: Fits ANSI B16.5 class 125,150,
250, and 300 flanges
End Detail Flanged: ANSI B16.5 class 150
(fits class 125) or
ANSI B16.5 class 300
(fits class 250)
Operating Pressure: 720 psi maximum
Maximum Differential: 150 psid continuous,
225 psid intermittent*
Reverse Pressure : 125 psid maximum
Temperature Range: 32 to 160 degrees F*
Flange Operating Pressure: Class 125-175 psi maximum
Class 150-275 psi maximum
Class 250-300 psi maximum
Class 300-720 psi maximum
Solenoid Enclosure: NEMA IV Watertight (std)
NEMA Vll Explosion Proof
(available)
Solenoid Voltages: 115, 230, 460 for 50, 60 HZ
6,12, 24,120, 240 VDC
* Standard natural rubber 65 durometer in water service.
Temperature range depends on liner material. Higher differential
pressure ratings available.
• Fast Acting Solenoid Control
• Reliable Drip-Tight Shut-Off
• Simple Design, Proven Reliable
• Optional Check Feature
• Easy Installation & Maintenance
Description
The Cla-Val Model 736-01 Solenoid Control Valve is an on-off control
valve which either opens or closes upon receiving an electrical signal
to the solenoid pilot control. This valve consists of a Cla-Val Model
100-42 main valve and a three-way solenoid valve which alternately
applies pressure to or relieves pressure from the loading chamber of
the main valve. It is furnished either normally open (de-energize solenoid
to open) or normally closed (energize solenoid to open).
If the check feature option is added and a pressure reversal occurs, the
downstream pressure is admitted into the main valve loading chamber
and the valve closes to prevent return flow.
For other than standard ANSI flanges consult factory
MODEL