Cla-Val 136-03/636-03 Valve Quick Manual - Manual (Page 2)

102C-3H
COVER
PIPE PLUG
COVER BEARING
SPRING
STEM NUT
DIAPHRAGM WASHER
DISC RETAINER
BODY
* SPACER WASHERS
DISC GUIDE
SEAT
PIPE PLUG
STEM
SEAT O-RING
STUD
8" and Larger
* DIAPHRAGM
* DISC
* Repair Parts
Seat Screw
8" and Larger
(Globe or Angle)
PIPE PLUG
HEX NUT
8" and Larger
Cover Bolt
6" and Smaller
1
4
D1
Y
F
B
1
A
INDEPENDENT
OPERATING
PRESSURE
B D2
2
3 S
B
H
DRAIN TO
ATMOSPHERE
INLET OUTLET
CS3
3 2
1
N.C.
N.O.
D3
COM.
For a more detailed IOM Manual go to www.cla-val.com or contact a Cla-Val Regional Sales Office.
CLA-VAL
Copyright Cla-Val 2008 Printed in USA Specifications subject to change without notice.
P.O. Box 1325 • Newport Beach, CA 92659-0325 • Phone: 949-722-4800 • Fax: 949-548-5441 • E-mail: [email protected] • Website cla-val.com
©
N-136-03/636-03 (R-11/08)
136-03/636-03 SCHEMATIC
HYTROL MAIN VALVE
OPTIONAL FEATURES
A X46A Flow Clean Strainer
B CK2 (Isolation Valve)
D Check Valves with Isolation Valve
F Independent Operating Pressure
H Atmospheric Drain
S CNA Angle Needle Valve (Opening)
Y X43Y Strainer
BASIC COMPONENTS
1 100-01 Hytrol (Main Valve)
100-20 600 Series Hytrol (Main Valve)
2 CS3 Solenoid Control
3 102C-3H Three-Way Valve
4 CNA Angle Needle Valve (Closing)
Wiring must comply with local and
National Electrical Codes. For valves
equipped with an explosion-proof,
watertight solenoid enclosure, the elec-
trical fittings must be approved for use
in the approved hazardous locations.
Housings for all solenoids have con-
nections for 1/2 inch conduit. The
enclosure may be rotated to facilitate
wiring.
SOLENOID WIRING
CS3
2
CNA
4
X46A
A
CK2
B
CV
C
X43
Y
102C-3H
3
CDC-1
D
Manual Operator
(Optional)
*SUGGESTED REPAIR PARTS
Cover
Washer, Diaphragm
Screw, Machine,
Fil. HD
Washer,
Lock
Body,
Powertrol
Spring
Seelskrew
Seat, Valve,
Upper
"O" Ring, Seat
Body
Gasket, Stem
Stem Assembly
"O" Ring,
Body to Body
Washer, Diaphragm,
Spring Retaining
Diaphragm
"O" Ring
Gasket, Stem
Screw, Machine
RD. HD.
Seat, Valve, Lower
3