Cla-Val 136-01/636-01 Solenoid Control Valve Quick Manual - Manual (Page 2)

COVER
PIPE PLUG
COVER BEARING
SPRING
STEM NUT
DIAPHRAGM WASHER
DISC RETAINER
BODY
* SPACER WASHERS
DISC GUIDE
SEAT
PIPE PLUG
STEM
SEAT O-RING
STUD
8" and Larger
* DIAPHRAGM
* DISC
* Repair Parts
Seat Screw
8" and Larger
(Globe or Angle)
PIPE PLUG
HEX NUT
8" and Larger
Cover Bolt
6" and Smaller
1
For a more detailed IOM Manual go to www.cla-val.com or contact a Cla-Val Regional Sales Office.
CLA-VAL
Copyright Cla-Val 2011 Printed in USA Specifications subject to change without notice.
P.O. Box 1325 • Newport Beach, CA 92659-0325 • Phone: 949-722-4800 • Fax: 949-548-5441 • E-mail: [email protected] • Website cla-val.com
©
N-136-01/636-01 (R-3/2011)
136-01/636-01 SCHEMATIC
HYTROL MAIN VALVE
OPTIONAL FEATURES
A X46A Flow Clean Strainer
B CK2 (Isolation Valves)
C CNA Needle Valve (Closing)
D Check Valves with Isolation Valve
F Independent Operating Pressure
H Atmospheric Drain
P X141 Pressure Gauge
S CNA Needle Valve (Opening)
V X101 Valve Position Indicator
Y X43 “Y” Strainer
X46A
CK2
CNA
X43
A
CS3
B
C
Y
2
BASIC COMPONENTS
1 100-01 Hytrol (Main Valve)
100-20 600 Series Hytrol (Main Valve)
2 CS3 Solenoid Control
Wiring must comply with local and National
Electrical Codes. For valves equipped with an
explosion-proof, watertight solenoid enclosure, the
electrical fittings must be approved for use in the
approved hazardous locations. Housings for all
solenoids have connections for 1/2 inch conduit.
The enclosure may be rotated to facilitate wiring.
SOLENOID WIRING
CDC-1
D
Manual Operator
(Optional)
*SUGGESTED REPAIR PARTS