Extron Electronics SW VGA_Ars Series User Guide - Manual (Page 24)

SW VGArs / Ars Series Switchers • Remote Control SW VGArs / Ars Series Switchers • Remote Control
Remote Control, cont’d
Using the help system
For information about program features, you can access the help
program in any of the following ways:
• Click Start > Programs > Extron Electronics >
Universal Switcher Control Help
.
• From within the Windows-based switcher control
program, select Help > Contents on the task bar.
• From within the Windows-based switcher control
program, press the F1 key.
VSW I AAP Remote Control
Each input of an SW VGArs / Ars Series switcher can be
connected to a VSW I AAP passive interface. The VSW I AAP
features a computer video input and pass-through, an
unbalanced stereo input and pass-through, and an input select
(Show Me) button. Pressing the VSW I AAP’s Show Me button
causes the switcher to select the input connected via that AAP.
SW6 VGA Ars REMOTE 100-240V 0.2A INPUTS
1
2
3
4
5
50-60Hz
OUTPUT OUTPUT
L R
SW6 VGA Ars
6
Projector
VSW I
AAP
SW6 VGA Ars
VSW I AAP COMPUTER AUDIO
SHOW ME
VSW I
AAP
VSW I AAP COMPUTER AUDIO
SHOW ME
VSW I
AAP
VSW I AAP COMPUTER AUDIO
SHOW ME
VSW I
AAP
VSW I AAP COMPUTER AUDIO
SHOW ME
VSW I
AAP
VSW I AAP COMPUTER AUDIO
SHOW ME
VSW I
AAP
VSW I AAP COMPUTER AUDIO
SHOW ME
Figure 4-12 — VSW I AAP application
Contact Closure Remote Control
The Remote connector also provides a way to select an input to
the switcher using a remote contact closure device. Contact
closure control uses pins on the Remote connector that are not
used by the RS-232 interface. The contact closure pin
assignments are shown in figure 4-1 on page 4-2.
To select a different input number using a contact closure
device, momentarily short the pin for the desired input number
to logic ground (pin 5). To force one of the inputs to be always
selected, leave the short to logic ground in place. The short
overrides front panel input selections.
IR 102 Infrared Remote Control
The optional Extron IR 102 kit consists of the following
components:
• IR 102 handheld remote control unit
• VersaTools IR 102 remote receiver with 3-foot cable and
RS-232 connector
• IR detector with 6-foot cable and captive screw connector
• External 12 VDC power supply
Install and operate the remote control in accordance with the
IR 102 User’s Guide included with the remote.
IR 102 Remote
Control Receiver IR 102 Remote Control IR Detector
3' Cable
6' Cable
Power
Supply
RS-232
Control
SW6 VGA Ars Switcher
SW6 VGA Ars REMOTE 100-240V 0.2A INPUTS
1
2
3
4
5
50-60Hz
OUTPUT OUTPUT
L R
SW6 VGA Ars
6
IR-102
+10 IR 102
Figure 4-13 — IR 102 Remote application
4-15 4-14