Extron Electronics SW2 VGA DA2 AF R User Guide Rev. A - Manual (Page 8)

SW2 VGA DA2 AF R • Installation and Operation SW2 VGA DA2 AF R • Installation and Operation
Installation and Operation, cont’d
Front Panel Features
UNSWITCHED
100-240V 5A MAX.
AUTO SWITCH
SW2 VGA DA2 AF R
1 2
INPUT
2
1 2 4 3 5 6 7 8 9
1 Auto-switching indicator LED — This LED lights when the
auto-switching feature is active.
2 Input 1 selection switch — Selects input 1
3 Input 1 indicator LED — This lights when input 1 is selected.
4 Input 2 selection switch — Selects input 2
5 Input 2 indicator LED — This lights when input 2 is selected.
6 Input 2 video — 15-pin HD female VGA connector
7 Input 2 audio — 3.5 mm female audio jack
8 AC power output connector — An unswitched standard IEC AC
power connector allows you to connect a peripheral device that
requires power.
This unit can operate at 100 to 240 VAC, 50/60 Hz with
the proper power cords.
9 Optional architectural adapter plates — One or two adapter
plates for pass-through audio/video connections can be
attached at one time to the switcher. See the “Installing Adapter
Plates” section in this chapter for installation instructions.
2-7
Under-desk mounting
1. Attach the under-desk mounting brackets
(part #70-212-01) to the SW2 VGA DA2 AF R with the four
provided machine screws, as shown in the under-desk
mounting diagram.
2. Hold the switcher with attached brackets against the
mounting surface. Use a soft pencil to mark the location of
holes for screws on the desk or other furniture.
3. Drill 1/4" (6.4 mm) deep, 3/32" (2.38 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside/inside (concealed side) of the
furniture, where the switcher will be located.
4. Attach the switcher to the desk with the provided wood
screws, as shown in the following illustration.
UN SW ITC HE D
10 0-2 40 0.5 A MA X.
AU TO SW ITC H
AC TIV E
SW2 VG A D A2 AF R
1
2
IN PU T 1
Under-desk mounting
2-6