Extron Electronics SW2 VGA DA2 AF R User Guide Rev. A - Manual (Page 5)

SW2 VGA DA2 AF R • Introduction
Introduction, cont’d
SW2 VGA DA2 AF R
2
Chapter Two
Installation and Operation
Installation Overview
Installing Adapter Plates
Mounting the SW2 VGA DA2 AF R
Front Panel Features
Rear Panel Features
Cabling
Operation
Troubleshooting
Introduction
About this Manual
This manual contains information about Extron’s
SW2 VGA DA2 AF R switcher and details on how to operate and
configure it.
About the SW2 VGA DA2 AF R
The SW2 VGA DA2 AF R is a high performance, full rack width,
two-input VGA switcher with 300 MHz (-3 dB) video bandwidth.
It accepts two VGA, SVGA, XGA, or UXGA computer-video
inputs and two stereo audio inputs. It features two buffered
VGA outputs and one stereo audio output. With an optional
Macintosh/VGA adapter, the SW2 VGA DA2 AF R can also
switch and distribute Macintosh signals.
Front panel buttons, a contact closure controller, or the auto-
switching option can be used for input selection.
Features
Auto-switching ability — The SW2 VGA DA2 AF R can detect
active sync signals and automatically switch to the active
input.
Furniture mountability — The SW2 VGA DA2 AF R can be
mounted under a desk or podium with optional
hardware, or it can be mounted in a rack with the
included VersaTools
™ rack mount kit.
Stereo audio — Unbalanced stereo audio inputs can be output
as balanced or unbalanced stereo audio.
AC power connector — International 100 to 240 VAC, 50/60 Hz,
internal switchable power supply.
Pass-through connectors — A wide assortment of architectural
adapter plates is available for installation on the
SW2 VGA DA2 AF R switcher to allow convenient pass-
through A/V connections.
1-2