Extron Electronics RGB 158xi VGA User Guide - Manual (Page 8)

RGB 138 xi, RGB 158xi Installation and Operation RGB 138 xi, RGB 158xi Installation and Operation
Installation and Operation, cont’d
3 Analog video input 15-pin HD male connector
4 ID bit termination DIP switches — These switches
provide proper ID bit termination when a
local monitor is not connected to the
interface’s buffered local monitor output.
DIP switch 1 connects pin 4 to ground.
DIP switch 2 connects pin 11 to ground.
ON — Set both switches (ID BIT 4 and
ID BIT 11) to On if no local monitor is
connected.
OFF — Set both switches to Off if a local
monitor will be attached to the interface.
5 Buffered local monitor output 15-pin HD female
connector
— This allows output to a local monitor.
Set the ID bit DIP switches to On if this connector is
not used.
6 Horizontal shift control knob — This control adjusts
the horizontal centering of the remote output display.
The horizontal shift control has no mechanical
limits to rotation. When the minimum or
maximum limit of the control is reached, the picture
will cease to move on screen, and the MIN/MAX
indicator LED will light red.
If the DDSP DIP switch is set to On, the horizontal
shift control is disabled.
7 MIN/MAX indicator LED — This LED lights red
whenever the lower or upper limits of the horizontal
or vertical shift controls are reached.
8 Optional architectural adapter plates — Up to four
adapter plates for pass-through audio/video
connections can be attached at one time to the
interface. See the “Installing Adapter Plates” section
in this chapter for installation instructions.
9 AC power output connector — An unswitched
standard IEC AC power connector allows you to
connect a peripheral device that requires power. This
feature is not available in Europe.
ID PIN 4 ID PIN 11
2-5
5 Horizontal shift control knob — This control adjusts
the horizontal centering of the remote output display.
The horizontal and vertical shift controls have no
mechanical limits to rotation. When the minimum
or maximum limit of the control is reached, the
picture will cease to move on screen, and the
MIN/MAX indicator LED will light red.
If the DDSP ™ DIP switch is set to On, the
horizontal and vertical shift controls are disabled.
6 Vertical shift control knob — This control adjusts
the vertical centering of the remote output display.
See the notes above for horizontal shift control.
7 MIN/MAX indicator LED — This LED lights red
whenever the lower or upper limits of the horizontal
or vertical shift controls are reached.
8 Optional architectural adapter plates — Up to four
adapter plates for pass-through audio/video
connections can be attached at one time to the
interface. See the “Installing Adapter Plates” section
in this chapter for installation instructions.
9 AC power output connector — An unswitched
standard IEC AC power connector lets you connect a
peripheral device that requires power. This feature is
not available in Europe.
RGB 158 xi front panel
1 2-color power/signal LED — This LED lights amber
to indicate power On only. It lights green to indicate
that power is On and a video signal is also present.
2 Audio input jack — This 3.5 mm stereo input jack
accepts an unbalanced stereo audio input.
UNSWITCHED
100-240 0.5A MAX.
RGB 158
H. SHIFT
MIN/MAX
INPUTS
AUDIO ANALOG
BUFFERED LOCAL
MONITOR OUTPUT UNIVERSAL INTERFACE W/ADSP
ID PIN 4 ID PIN 11
1 3 5 7 8 9 2 6 4
2-4