Extron Electronics CrossPoint 300 Series - Manual (Page 13)

1-5 CrossPoint 300 Matrix Switchers • Introduction
Operational flexibility — Operations such as input/output selection, setting of
presets, and adjustment of audio levels can be performed on the front panel
or via either serial port. The serial ports also allow remote control via a PC or
control system.
• QuickSwitch Front Panel Controller (QS-FPC™) — The front panel
controller supports input and output selection, preset creation and selection,
audio input gain and attenuation, and audio output level. The front panel
features slots for labels that can identify each input and output with text or
graphics.
• Windows-based control program — For serial port remote control from a PC,
the Extron Windows-based control software provides a graphical interface
and drag-and-drop/point-and-click operation. The Windows-based control
program also has an emulation mode that lets you create a switcher
configuration file at the home office and then download it for use by the
switcher on site.
• Simple Instruction Set (SIS ™ ) — The remote control protocol uses the Extron
SIS for easy programming and operation.
• Remote control panels and keypads — The matrix switchers are remote
controllable, using the optional MKP 2000 and MKP 3000 remote control
keypads. The remote control devices are easy to use and provide tactile
buttons for quick selection. Each MKP can be used for input-to-output
switching, one-touch switching for a particular output. The MKP 3000 also
can be used for selection of global presets.
Upgradeable firmware — The firmware that controls all switcher operation can be
upgraded in the field via either serial port without taking the switcher out of
service. Firmware upgrades are available for download on the Extron Web
site, www.extron.com, and they can be installed using the Windows
® -based
control program.
Labeling — The Extron Button Label Generator software ships with every Extron
matrix switcher. You can create labels to place above the front panel input
buttons and below the output buttons, with names, alphanumeric characters,
or color bitmaps for easy and intuitive input and output selection.
Alternatively, labels can be made with any Brother
® P-Touch ™ or comparable
labeler.
Global memory presets — 20 or 32 (depending on the model) global memory
presets are a time-saving feature that lets you set up and store input/output
configurations in advance. You can then recall those configurations, when
needed, with a few simple steps.
Rack mounting — Rack mountable in any conventional 19" wide rack.
Three front panel security lockout modes (Executive modes) — If a matrix
switcher is installed in an open area, where operation by unauthorized
personnel may be a problem, either of two security lockout modes can be
implemented (the third mode is unlocked). When a front panel locked mode
is enabled, a special button combination or SIS command is required to
unlock the front panel controller and make the front panel fully operational.
Power — The matrix switcher’s 100 VAC to 240 VAC, auto-switching, internal
power supply provides worldwide power compatibility.