Extron Electronics TMK Series Installation - Manual (Page 2)

US B CHA
RGE R
USB CH ARG ER
Tighten
Tighten
USB CH ARG ER
USB CH ARG ER
1
Install #6 x 1/2 inch wood screws
into the pilot holes.
Tighten until 1/4 inch protrudes.
Drill 3/32-inch (2.4 mm) diameter,
1/4 inch (6.3 mm) deep pilot
holes.
Mark the four keyhole locations at
the desired mounting location.
2
Slide the faceplate onto the screws.
Tighten the front keyhole screws only.
5
4
3
Connect the cables and wiring
to the AAPs.
7
6
8
Install the two sheet metal screws to
secure the faceplate and cover
together.
Tighten the two rear keyhole screws
through the openings in the cover.
9
Install AAPs in the faceplate.
(4)
Faceplate
Screws (2)
Slide the cover up and into the faceplate.
Make certain the rear slots of the cover
slide into the rear keyhole screws.
Extron USA Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.8 50.1000
+1.714.491.1517 FAX +1.919.8 50.1001 FAX
Extron Europe
+800.3987.6673 (Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX Extron India
1800.3070.3777 (Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
68-2456-50
Rev. A
11 13