beautypg.com

Extron Electronics TMK Series Installation User Manual

Tmk series • installation guide, Attention, Included parts

background image

IMPO

RTAN

T:

Go to www

.extron.com

for the

complete user guide

, installation

instructions,

and specifications.

TMK Series • Installation Guide

The TMK series Table Mount Kits allow under-table installation for up to two single-space

AAPs (TMK 120 AAP) or up to three single-space AAPs (TMK 130 AAP). Both kits secure

to the underside of a table. The kits can also be mounted side-by-side for applications

requiring additional AAP spaces.

NOTE:

The location must consider that cables are connected to the AAPs both from

the front and from the rear, and the bracket and AAPs must be readily visible to
prevent accidental contact.

ATTENTION:

Do not drill through the table or furniture. If the table is too thin or of a

different material for the supplied screws, use an appropriate type and length.

US

B CHA

RGE

R

USB

CH

ARG

ER

Tighten

Tighten

USB

CH

ARG

ER

USB

CH

ARG

ER

1

Install #6 x 1/2 inch wood screws
into the pilot holes.
Tighten until 1/4 inch protrudes.

Drill 3/32-inch (2.4 mm) diameter,
1/4 inch (6.3 mm) deep pilot
holes.

Mark the four keyhole locations at
the desired mounting location.

2

Slide the faceplate onto the screws.
Tighten the front keyhole screws only.

5

4

3

Connect the cables and wiring
to the AAPs.

7

6

8

Install the two sheet metal screws to
secure the faceplate and cover
together.

Tighten the two rear keyhole screws
through the openings in the cover.

9

Install AAPs in the faceplate.

(4)

Faceplate
Screws (2)

Slide the cover up and into the faceplate.
Make certain the rear slots of the cover
slide into the rear keyhole screws.

#4 x 1/4" (2)
Sheet Metal Screws

#6 x 1/2" (4)
Wood Screws

Cover

Faceplate

Included Parts

Mount the TMK bracket as follows: