Extron Electronics TLI Pro 101 Setup Guide - Manual (Page 2)

2
TLI Pro 101 • Setup Guide (Continued)
Configure the Interface
The Global Configurator Professional Help File, the Global Configurator Plus Help File, and the GUI Designer Help File provide
step-by-step instructions and more detailed information. The Global Configurator Professional and Global Configurator Plus help
files include an introduction to the software and sections on how to start a project and configuration.
Rear Panel Connectors and Features
For complete information about the TLI Pro 101 rear-panel connectors and features, see the TLI Pro 101 User Guide.
TLI PRO 101
LAN/PoE
USB
HDMI HDMI
+ -
POWER
12 V
RESET
CONTROL OUTPUT
1.0A MAX
INPUT
A B G F E C D
Figure 1. TLI Pro 101 Rear Panel
ATTENTION: The TLP Pro 720C can use a 12 VDC desktop power supply and is also Power over Ethernet (PoE 802.3af,
class 3) compliant. Do not connect either power supply before reading the Attention in the Power Supply section of the
TLP Pro 720C User Guide.
ATTENTION: Le TLP Pro 720C peut utiliser une source d’alimentation externe 12 Vcc, et est également compatible avec
l’alimentation POE via Ethernet (PoE 802.3af, classe 3). Ne branchez pas de sources d’alimentation externes avant d’avoir
lu les mises en garde dans la section « Power Supply » du TLP Pro 720C User Guide.
A Power connector — Connect the 2-pole, 3.5 mm captive screw connector from the provided 12 VDC, 1.0 A power supply to
this socket.
NOTE: The TLI Pro 101 also complies with Power over Ethernet standards (PoE 802.3af, class 3).
B HDMI input — Plug the cable from the input source device into this female HDMI type A connector. Use the provided LockIt
brackets to secure the connector to the TLI Pro 101 unit.
C HDMI output — Connect this female HDMI type A connector to a third-party touch screen. Use the provided LockIt brackets
to secure the connector to the TLI Pro 101 unit. A full list of compatible resolutions is provided in the TLI Pro 101 User Guide.
D USB connector — supports High-speed USB 2.0 control. Plug a USB cable from the third-party touchpanel into this female
type B connector.
NOTE: To use a monitor that is not a touchpanel, connect a mouse to this port.
E Network and Power over Ethernet connector — Connect the interface to the LAN using a twisted pair cable, terminated
with an RJ-45 connector. The connector can also be used with a PoE power injector (not provided).
An Extron IP Link Pro control processor must also be connected to the same network as the TouchLink Pro touchpanel.
F Reset button (recessed) — allows the unit to be reset in any of three different modes. For more information about Reset
modes see the TLI Pro 101 User Guide.
G Reset mode LED — indicates power status and reset status of the device.