Extron Electronics SCP 100 Control Pad User Guide - Manual (Page 10)

System 5 cr • SCP 100 User’s Manual • Extron
Operation
SCP 100 Operation
The SCP 100 panel replicates the normal operations of the front
panel. The function names are the same. As stated earlier, Setup
(or Config) Mode operations cannot be done from the SCP 100.
The IR Remote port receives IR 40 signals and sends them to the
System 5 by the cable. Signals from other IR devices are blocked
at the System 5.
Any “learned” IR commands that are stored in the System 5
memory will be transmitted from the System 5’s IR emitter or the
optional IR Broadcaster when the associated button is pressed on
the SCP 100 panel, just as it will when that same front panel
button is pressed.
Figure 2-1. SCP 100 panel controls are similar to those on the front panel.
Room Button and LED
This button and LED work with the relay contact connections
provided on the rear panel of the System 5. The button can
activate/deactivate a room condition, such as turn lights on/off and
raise/lower a viewing screen. The LED indicates when the
condition exists. Exactly how the feature is used depends upon
the user-defined application and what is connected to the “Relay”
connector on the rear panel.
2-1