Extron Electronics PowerCage MPT R 15HD RSA SEQ Setup Guide User Manual
Installation, Mtp t 15hd rsa only
Installation
1.
Select an open slot at the rear, or take out a blank plate or installed board by
loosening the two screws (top and bottom), and lifting it away.
2.
Hold the new board with the signal connectors towards you and the LED at
the top. Carefully slide the board into the slot, aligning the two tabs on the
lower front end of the board with the matching ports in the enclosure.
Push it firmly into place.
3.
Tighten the screws to secure the board in place. If needed, repeat steps 1
through 3 for other boards.
4.
If power has been removed, reconnect and power on the PowerCage. The new
board is auto-detected.
The LED on the board lights green when power is applied.
5.
MTP T 15HD RSA board — Connect RGB, HD-YUV, YUV, S-video, or composite
video inputs to the 15-pin HD VGA connector.
MTP R 15HD RSA SEQ board — Connect suitable display devices to the 15-pin HD VGA connector for RGBHV, RGBS,
RGsB, RsGsBs, HD-YUV, YUV, S-video, or composite video output.
6.
MTP T 15HD RSA board — Connect an audio input source to the 5-pole captive screw connector. Wire the captive screw
connector as shown below. Use the supplied tie-wrap to secure the audio cable to the connector.
L
R
Unbalanced Stereo Input
Balanced Stereo Input
Ring
Sleeve (s)
Tip
Sleeve
Tip
Sleeve
Tip
Tip
Ring
Do not tin the wires!
MTP R 15HD RSA SEQ board — On this board, there is a combined audio and RS-232 output connector. Wire and insert
a 5-pole captive screw connector for mono audio and/or RS-232 serial output. Wire the connector as below.
Receive (Rx)
Transmit (Tx)
Ground ( )
Bidirectional
Mono Audio Output
RS-232 Output
Tip
Ring
Sleeve
Rx
Tx
RS-232
Device
Ground ( )
Receive (Rx)
Transmit (Tx)
Rx
Tx
Do not tin the wires!
7.
MTP T 15HD RSA board — Connect the transmitter to a suitable MTP receiver via
the RJ-45 output connector.
MTP R 15HD RSA SEQ board — Connect the twisted pair cable from the transmitter
to the RJ-45 input connector.
NOTE:
Terminate the twisted pair cable as shown right, using the same
standard (TIA 568A or TIA 568B) at both ends.
8.
MTP T 15HD RSA only —
Connect to the 3-pole captive screw connector
for bi- or unidirectional RS-232 communication. The RS-232 function is only available by
setting the DIP switch on the board from audio to RS-232 communication. The default
is audio.
The Extron
®
PowerCage MTP T 15HD RSA (transmitter) and MPT R 15HD RSA SEQ
(receiver) boards are twisted pair transmitters and receivers in a modular board
format for the PowerCage 1600 enclosure.
Refer to the PowerCage MTP 15HD RSA Series User Guide, and the
PowerCage 1600 Enclosure User Guide, online at
NOTE:
The hot-swappable, modular design allows the replacing or
upgrading of boards in the field at any time, without having to
power down the system
M
O
N
O
A
UDIO OUTPUT
1
2
S
H
A
R
P
GAIN
Y/VI
D
C
INPU
T
Po
we
rCa
ge
MTP R
AV
Tx
R
x
HD/SDI INPUT
HD/SDI OUTPUT
S
M
O
D
E
Po
we
rCa
ge
FO
X 3G HD-SD
I
1
2
REMO
TE
RS-232
RS-232
O
VER FIBE
R
Tx Rx
Tx
ALAR
M
Rx
OUTPUT
RG
B
Po
we
rCa
ge
FO
X 4G
RX
RG
B
Tx Rx
L
R
A
UDI
O
5A MA
X.
100-2
40V 50
/60H
z
N15
778
C
US
LIS
TED
1T2
3
I.T.
E.
Screws
(2 per board)
1
2
REM
O
T
E
RS-232
RS-232
O
VER FIBE
R
Tx Rx
Tx
ALAR
M
Rx
OUTPUT
RG
B
Po
we
rCa
ge
FO
X 4G RX
RG
B
Tx Rx
L
R
A
UDI
O
Align board and
slide into slot.
16 available single board slots or
8 double board slots
Power
Supply
Transmitter
Receiver
OUTPUT
AUDIO RS-232
Tx
ADJUST
SELECT
R
G/L
B/P
Rx
INPUT
PowerCage
MTP R
15HD RSA SEQ
AUDIO INPU
T
RS-232
Tx Rx
L
R
OUTPUT
INPU
T
PowerCage
MTP T
15HD RSA
PRE-PEAK
ON
OF
F
Continued on side 2.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
T568A
T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Blue
Blue
Insert Twisted
Pair Wires
Pins:
12345678
RJ-45
Connector
NOTE:
The receiver auto-detects whether the
signal on the audio/RS-232 pair of the TP
input is audio or RS-232. It then converts
the signal content accordingly, and
outputs it on the appropriate pins of the
connector.
PowerCage MTP T 15HD RSA and MPT R 15HD RSA SEQ Board Setup Guide
1