Extron Electronics MDA 4V SDI User Guide - Manual (Page 7)

MDA 4V HD-SDI and SDI User's Guide • Introduction
MDA 4V HD-SDI and SDI User's Guide
MDA 4V HD-SDI and SDI User's Guide • Introduction MDA 4V HD-SDI and SDI User's Guide • Installation MDA 4V HD-SDI and SDI User's Guide • Installation
MAV SER IES
AV MA TRIX SWITCHER I/O
AUD
AUD IO S ETU P
PRE SET
VID
IR
+dB
-dB
ENT ER
2
7
6
5
2
4
1
INPU TS
OUT PUT S
8
3
1
8
6
5
4
3
7
Rear
Front
Figure 6 — Typical back of the rack installations
Furniture mounting
Furniture mount the MDA using the optional MBU VersaTools
under desk mounting kit (part #70-212-01) as follows:
1
. Attach the mounting brackets to the MDA with the
provided machine screws (figure 7).
DIST RIB UTIO N A MPL IFIE R
Figure 7 — Under-desk mounting the MDA
2 . If feet were previously installed on the bottom of the MDA,
remove them.
3 . Hold the MDA with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
6 . Align the mounting screws with the slots in the brackets
and place the MDA against the surface, with the screws
through the bracket slots.
7 . Slide the MDA slightly forward or back, then tighten all
four screws to secure the MDA.