Installation – Extron Electronics IN2118 User Manual

Page 6

Installation

MOUNTING THE INTERFACE

WARNING: The IN2118 should only be mounted by licensed and bonded installers. Care
must be taken to avoid scarring or damaging presentation / conference room furniture.

Before installing the IN2118, refer to the Dimensions Diagrams on pages
22 - 24 and make sure the table / installation furniture will accommodate
all the dimensions of the unit.

In the following example, the IN2118 is installed in a conference room table with a laminated
surface. Depending on the installation, your emplacement may require specialized tools,
additional materials, safety equipment, etc.
Hint: To simplify your installation, make the lid fit the hole, not vice versa.

NECESSARY TOOLS & SUPPLIES:

Power Tools:

Hand Tools:

Miscellaneous:

Drill
Router
Saw (Circular or Saber)

IN9185 Template
Carpenter’s Level
(2) C-Clamps
Wood File
Phillips Screwdriver

Adhesive
Double sided tape
Wood Screws and

Washers

1/32” Feeler Gauge
(Optional)

1. Locate the desired mounting location on the tabletop / installation furniture surface and

mark the center with a pencil.

2. Attach the extension arms to the optional IN9185 Table Routing Template and position it

around the center mark. Make sure that the 12 flat head screws are countersunk below
the surface of the extension arms. Failure to do so may scar the furniture.

3. Once the Template has been situated properly, use a pair of C-Clamps to secure the

extension arms to the edges of the table. Use a pencil to outline the 9 ½” x 8 ½” inside
edge of the template (see the Installation Diagram on the following page).

Hint: Marking the inside edge of the IN9185 will alert the installer of any accidental
template movement that may occur while routing the hole.

4. Using a router, carefully cut the opening in the table surface (very thick table surfaces

may require additional routing). Use a file to square the round edges. Remove the
template when finished.

When using the IN9185, installers must use a router bit template guide
(collar) that provides ¼” clearance from the inside edge of the template.