Extron Electronics ISM SC Output Board - Manual (Page 3)

N X! = Input number, 0-8
X@
= Output number, 0-8
Command ASCII
command
(host to
switcher)
Response
(switcher to
host)
Additional description
Input selection
Video and
audio X! *X@! OutX@•InX!•All] Select video and audio input X! to
output X@.
Example 4*2! Out2•In4•All] Input 4 video and audio selected
to output 2.
Video X! *X@& OutX@•InX!•RGB] Select video input X! to output X@.
Example 5*2& Out2•In5•RGB] Input 5 video only selected to
output 2.
Audio X! *X@$ OutX@•InX!•Aud] Select audio input X! to output X@.
Example 5*2$ Out7•In3•Aud] Input 3 audio only selected to
output 7.
Video output type
Set video
output type
to X\ 36*X@*X\# X@ TpoX\] Select video output format to X\
Where X\ = 0 = S-video, 1 = YUV,
2 = RGsB.
View 36*X@# X\] View the video output format.
Test pattern
The test pattern submenu offers the following test patterns to choose from:
Full Screen
The Full Screen submenu allows per-input setting of the displayed image on the output screen.
When set to Off (default) the aspect ratio follows input resolution and the output image retains
the input setting. When set to On, the aspect ratio follows the output resolution, and the
displayed image always fills the screen.
Board-specific SIS commands table
Alternatively, the ISM SC board can be configured with specific SIS commands.
The table below lists some of the ISM SC board-specific commands. For a full list of SIS
commands refer to the ISM 824 User’s Manual, online at www.extron.com .
3
SIS command table continues on page 4.
NTSC/PAL Color Bars
Grayscale 4x4
Crosshatch
32x24
Crosshatch
1.78 Crop 1.85 Crop 2.35 Crop 1.33 Crop Crop
Ramp
Safe Area