Under-furniture mounting, Chapter three, Operation – Extron Electronics ADA 2_GLI 350xi User Manual
Page 9: Under-furniture mounting -6, Chapter three • operation
GLI 350xi & ADA 2/GLI 350xi • Installation
Installation, cont’d
2-6
GLI 350xi & ADA 2/GLI 350xi
Under-furniture mounting
The GLI 350xi or ADA 2/GLI 350xi can be mounted under
furniture, such as a desk or table, using the optional MBU 125
mounting kit (Extron part #70-077-01), as follows.
1
.
If rubber feet were previously installed on the bottom of
the unit, remove them.
2
.
Attach the mounting brackets to the GLI with the provided
machine screws.
Under-furniture mounting of the GLI
3
.
Hold the unit with the brackets attached against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4
.
Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" deep (6.3 mm) in the mounting surface at the marked
screw locations.
5
.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6.3 mm) of the screw head protrudes.
6
.
Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7
.
Slide the unit slightly forward or back, then tighten all four
screws to secure the unit in place.
3
Chapter Three
Operation
Front.Panel.Features.and.Operation
Rear.Panel.Features.and.Operation