Extron Electronics Extender Plus Series Setup Guide User Manual
Extender plus series • setup guide, Step 1, Step 2
STORE
50
Hz
0
1
2
34
56
7
8
9
A
B C D E
F
60
SELECT
EDID
a
a
2
a
4
a
3
Extender Plus Series • Setup Guide
ATTENTION:
Potential Damage to Property. Installation and service must be
performed by authorized personnel only. These products must be used with UL approved,
grounded electrical boxes.
Step 1
Configure EDID Minder at the display device. The Extender Plus models offer two ways of
configuring EDID:
•
EDID Record — Enables the device to record EDID
directly from a display.
1.
Turn the rotary switch (
a
) to position 0.
NOTE:
The DIP switch positions have no
effect in this mode.
2.
Apply power to the Extender by connecting the
12 VDC power supply. The green LED (
b
) lights
when power is available.
3.
Connect the display device to the input of the Extender using a VGA cable.
4.
Power on the display device.
5.
Press and release the recessed EDID store button (
c
). The LED flashes red while
storing the EDID, then it turns solid green when the EDID data has been stored. The
display can now be disconnected.
NOTE:
If an external supply was used for recording, it can now be disconnected.
•
Pre-programmed EDID — The Extender Plus models contain pre‑programmed EDIDs with
the most common display native resolutions for both 50 and 60 Hz.
1.
See Table 1 on page
9 of the Extender Plus Series User Guide to see which
resolution corresponds to each rotary switch (
a
) position. Set the rotary switch to
the native resolution of the display.
2.
Set the first DIP switch (
d
) to the vertical refresh frequency of the display (default is
ON, 60 Hz).
Step 2
Turn all of the equipment off and disconnect the power cords from the power source.
Step 3
Select the installation location and install the electrical wall box. See “Installation
Instructions” on page 2 of the Extender Plus Series User Guide for details on installing the
wall box and cables.
NOTE:
The Extron Extender Plus AAP does not require a wall box if it is installed into an
Extron HSA 400 Series or HSA 800 Series surface access product.