Extron Electronics Fiber Optic Termination Kit - Manual

2. Slide the appropriate size boot onto the
cable with the threads toward the end to be
terminated.
To Terminate a Fiber Cable
1. Lay the required tools and components out on a
clean work surface. Begin by placing the cable
clamp about 10 inches from the end of the cable.
This will prevent the inner cable from being pulled
out as the cable is stripped.
3. Set a connector with wedge clip into the
assembly tool.
NOTE: The wedge clip is engaged at shipment.
If it has become dislodged, squeeze the
top and bottom ensuring the wedge clip is
inserted into the connector body. A click
will be heard.
2
1
1
2
3
Fiber Optic Termination Kit • User Guide
This guide provides instructions for the Extron Fiber Optic Termination Kit. The kit contains
the necessary tools required for an experienced technician to properly terminate LC single
or multimode 2 mm fiber optic cable.
NOTE: Visit the fiber optic termination kit page at www.extron.com for an interactive
video describing how to terminate an LC connector using this kit.
The following items are included in this kit:
Fiber Stripper
Visual Fault Locator
(VFL)
Installation
Instructions
Fiber Preparation
Fluid
Marker Pen
Lint-free Cloth Wipes
Cleaver w/
Case
Kevlar ® Scissors Cleave/Strip
Gauge Cable Clamp
Cable Grip
Assembly Tool
Extro n ® Fiber Opt ic Str ip/Clea ve Le ngth Extro n Ele ctronics Anaheim , CA www.e xtron .com
68-20 49-0 1 A
Mark C able Boo t
2mm and 3mm Fiber C able Strip 40 mm Strip 70 mm
11.5 m m (LC)
Buffer
Buffer Kevlar Strans
Glass F iber Core Jacket
HOLD 1 se
c VFL 101
WARNING: To prevent eye damage, always wear eye protection when handling
optical fibers. Do not touch the glass fiber. Dispose of cut or cleaved ends
properly.