Installation, cont’d – Extron Electronics DVS 150 User Manual
Page 14
Installation, cont’d
DVS 100 and DVS 150 Installation
2-4
Rubber Feet
Bottom Side (4 Plcs)
RAT
E
V S
HIF
T
H S
HIF
T
CO
NTR
AST
BR
IT
TIN
T
CO
LO
R
1
2
3
DVS 100
DIG
ITA
L V
ID
EO
S
CA
LE
R
IN
PU
T
Figure 3 — Mounting the scaler
Installing the rubber feet
The scaler ships with four uninstalled rubber feet. Install the rubber feet
only if you are not rack mounting the scaler. To install the rubber feet,
do the following:
1.
Turn the scaler upside down and place it on a flat surface.
2.
Remove the protective backing from a rubber foot.
3.
Place the rubber foot on one corner of the scaler as shown in figure
4, and press it into place.
Position the rubber foot carefully before pressing it into place. It is
difficult to move the foot after it is in place.
Figure 4 — Installing the rubber feet
4.
Repeat steps 2 and 3 to install a rubber foot on each of the
remaining corners of the scaler.
5.
Turn the scaler right side up and place it in the desired location.
(2) 4-40 x 1/8" Screws
Use 2 mounting holes on
opposite corners
False front panel
uses 2 front holes
RAT
E
V S
HIFT
H S
HIFT
CO
NTR
AST
BR
IT
TIN
T
CO
LO
R
1
2
3
DVS 100
DIG
ITA
L V
IDE
O S
CA
LE
R
INP
UT