Extron Electronics DMS 1600_2000_3200_3600 Setup Guide - Manual (Page 4)

DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Introduction 1 vi DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Contents
Introduction
WARNING: Risk of serious physical injury — The DMS fiber
optic I/O boards output continuous invisible light, which may be
harmful to the eyes; use with caution.
• Do not look into the fiber optic cable connectors or into the
fiber optic cables themselves.
• Plug the attached dust caps into the optical transceivers when
the fiber cable is unplugged.
This section gives an overview of this guide and the DMS 1600, DMS
2000, DMS 3200, and DMS 3600 and describes their features. Topics
that are covered include:
• About this Guide
• About the DMS Matrix Switchers
About this Guide
NOTES:
• For more information on any subject in this guide, see the DMS
Series Matrix Switcher User Guide, available on the Extron DVD
or at
www.extron.com .
• Throughout this guide, all of the covered switchers are referred
to as "DMS matrix switchers" unless a significant difference is
noted in their features or operation.
This setup guide helps you to easily and quickly set up and configure
your Extron DMS matrix switcher. Step by step instructions show you
how to:
• Install the input and output boards .
• Connect the hardware .
• Perform basic operations
• Use both the front panel controls and selected
Simple Instruction Set commands .
• Load and start the Matrix Switchers Control Program .
• Connect to the built-in HTML pages , which you can use to operate
the switcher.
• Reconfigure the switcher by adding or removing boards, power
supplies, and fans.