Extron Electronics DTP DVI 230 D User Guide - Manual (Page 8)

DTP DVI 230 D Transmitter and Receiver • Introduction 2
Twisted Pair Cable Advantages
Twisted pair cable is much smaller, lighter, more flexible, and less expensive than coaxial
or DVI cable. These transmitter and receiver twisted pair (TP) products make cable runs
simpler and less cumbersome. Termination of the cable with RJ-45 connectors is simple,
quick, and economical.
NOTE: Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
cable to link the transmitter and receiver. The DTP HDMI 230 Tx/Rx does not work
properly with these cables.
Transmission Distance
The maximum transmission distance is determined by the resolution of the signal and the
twisted pair cable that is used.
Features
Transmits single link DVI-D signals over one CAT 5e, 6, 6a, or 7 cable — Standard
twisted pair cables provide an economical, easily installed cable solution.
With CAT 5e, 6, 6a, or 7 UTP or STP cable — The transmitter and receiver pair can
transmit and receive 720p, 1080i or 1080p HDTV, or XGA video signals up to
230 feet (70 m).
Supports DDC and HDCP copy protection transmission — The transmitter and
receiver pair fully supports long distance transmission of the DDC and HDCP signals.
Control communications pass-through — Bidirectional RS-232 or IR control signals can
be transmitted alongside the DVI signal, so that the remote display can be controlled without
the need for additional cabling.
Audio routing — The DTP DVI 230 D transmitter and receiver also route unbalanced stereo
audio.
Supports CEC signal transmission
Wall-mountable enclosures
External 100 VAC to 240 VAC, 50-60 Hz, international power supply — Included with
transmitters.
Remote powering of transmitter or receiver — Only one power supply is necessary to
power both devices.