Transmitter rear panel, Ear of the unit (see – Extron Electronics DTP DVI 230 D User Guide User Manual
Page 13
DTP DVI 230 D Transmitter and Receiver • Introduction
7
c
Audio input — Connect an unbalanced stereo audio source to this 3.5 mm mini stereo
jack for unbalanced audio input. Figure 5 shows how to wire the audio plug.
Sleeve ( )
Ring
Right (-)
Tip
Left (+)
Figure 5.
Audio Input Connector Wiring
d
RS-232 and IR (Control) pass-through connector — Connect a serial
communications port to this 3.5 mm, 5-pole captive screw connector for bidirectional
RS-232 communication and IR communication (see
on page 12 to wire the connector).
e
DDC Route switch — This switch selects either the remote or local DVI display as the
Display Data Channel (DDC) reference for EDID and HDCP communication.
Transmitter Rear Panel
DO NOT
CONNECT
TO LAN
DTP 230 D Tx
POWER
12V
0.8 A MAX
SIG
LINK
DTP OUT
2
1
Figure 6.
DTP DVI 230 D Transmitter Rear Panel Connectors
a
DC power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver (see
on page 11 to wire the connector).
b
Transmitter output port — Connect one end of a twisted pair cable to this RJ-45
output port.
ATTENTION: Do not connect this device to a telecommunications or computer
data network.