Receiver connections, Receiver rear panel, Receiver front panel – Extron Electronics DTP HDMI 230 D User Guide User Manual
Page 14
DTP HDMI 230 D Transmitter and Receiver • Installation and Operation
8
Receiver Connections
The wall-mountable receiver is in an enclosure that can be mounted in UL-listed standard
wall boxes with Decora-style face plates.
Receiver Rear Panel
Figure 7 shows the rear panel of the DTP HDMI 230 D receiver.
SI
G
LIN
K
DTP IN
POWER
12V
0.8 A MAX
DTP 230 D Rx
1
2
Figure 7.
DTP HDMI 230 D Receiver Rear Panel Connectors
a
Receiver input ports — Connect the opposite end of the twisted pair cable from the
transmitter output connector (see
b
on the previous page) to this RJ-45 connector (see
on page 10 to properly wire the RJ-45 connectors).
ATTENTION: Do not connect this device to a telecommunications or computer
data network.
b
DC power input connector — Plug the included external 12 VDC power supply
into either this 2-pole connector (see
on page 11 to
wire the power connector) or the power input connector on the transmitter (see
a
on the previous page).