Extron Electronics DTP HDMI 230 D User Guide - Manual (Page 13)

DTP HDMI 230 D Transmitter and Receiver • Installation and Operation 7
c
RS-232/IR (Control) pass-through connector — Connect a serial communications
port to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232
communication (see
RS-232 and IR connector wiring on page 12 to wire the
connector).
NOTE: The RS-232 connector can also transmit one-way modulated infrared (IR)
signals.
Transmitter Rear Panel
SIG LINK
DTP OUT
POWER
12V
0.8 A MAX
DTP 230 D Tx
2
1
Figure 6. DTP HDMI 230 D Transmitter Rear Panel Connectors
a
DC power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector (see
Power supply wiring on page 11 to wire the power
connector) or the power input connector on the receiver (see b on the following page).
b
Transmitter output port — Connect one end of the twisted pair cable to the
RJ-45 connector on the transmitter (see
Connector and Cable Details on page 10 to
properly wire the RJ-45 connectors).
ATTENTION: Do not connect this device to a telecommunications or computer
data network.